| From | 1 | 4 | 7 | 6 | 7 | 11 | 5 | 19 | 21 | 2 | 15 | 12 | 13 |
| To | 3 | 6 | 10 | 8 | 9 | 16 | 18 | 20 | 14 | 15 | 17 | 14 | 15 |
220 V,
DC supply
3-point
starter
Voltmeter
Ammeter
Voltmeter
RC
RF
Ammeter
Main Winding
Rotor View
| Sl. | Field current (A) | Armature Current (A) | Armature Voltage (V) | Voltage Across Rc (V) | Value of Rc (Ohm) | Speed (rpm) |
|---|
| Sl. | Armature current (A) | Armature Voltage (V) | Field Current (A) | Speed (rpm) |
|---|
Armature voltage VS speed of DC shunt motor
Field current VS speed plot of DC shunt motor
Instructions
Step 1: Make the proper connection by clicking the node as instructed below. If the wire is misplaced, click the node number to deattach the nodes' wire.
Step 2: Click "Check" button.
if connection is correct, an alert appers. Click ok. Now, go to step 4.
if connection is wrong, an alert appers. Click ok. Now, go to step 3.
Step 3: Check the connection, if incorrect, click on node number to remove any
particular connection(s) or click on reset button and start from step 1.
Step 4: Switch on the Power Supply
Step 5: Move the slider to change the Auto Transformer values
Step 6: Take readings from Wattmeter, Voltmeter, and Ammeter.
Step 7: Follow the procedure
Step 8: Click "Print" button, to print the full connections with graph and table in landscape mode.
Step 1: Make the proper connection by clicking the node as instructed below. If the wire is misplaced, click the node number to deattach the nodes' wire.
| From | 1 | 4 | 7 | 6 | 7 | 11 | 5 | 19 | 21 | 2 | 15 | 12 | 13 |
| To | 3 | 6 | 10 | 8 | 9 | 16 | 18 | 20 | 14 | 15 | 17 | 14 | 15 |
Step 4: Switch on the Power Supply
Step 5: Move the slider to change the Auto Transformer values
Step 6: Take readings from Wattmeter, Voltmeter, and Ammeter.
Step 7: Follow the procedure
Step 8: Click "Print" button, to print the full connections with graph and table in landscape mode.